INSTALLATION


STAFFI1

Comfort Roof Control Module for

  • Ferrari 360 Spider
  • Ferrari F430 Spider

    v1


    • Further information and manuals for all products can be found on our web site

    w w w . m o d s 4 c a r s . c o m

     
    We explicitly point out that all functions of this control unit should be used only while exercising caution and responsibility. We can NOT be held liable for any damage or injury caused by installing or using this product.
    PLEASE READ THE COMPLETE MANUAL CAREFULLY BEFORE USING THIS PRODUCT.
    Important Information. READ BEFORE INSTALLING!
    PRINTING THIS MANUAL
    This manual is designed to produce completely filled pages. In order to get best print results, simply set the borders to minimum settings in the browser's page setup menu and disable headers and footers.

    Activate the print preview and if necessary decrease the zoom level until all pages are shown correctly.

    ALL IMAGES CAN BE CLICKED FOR FULL SIZE in the browser.
    TROUBLE SHOOTING - NEED TO CONTACT US?
    If you run into any problems after installing the module, please go over the manual again in great detail, clicking every photo for full size!
    We now have a full Knowledge Base with Support Ticket system available online at www.mods4cars.com/support

    If you need to contact us, the best and fastest way to do so is by opening a support ticket there

    This module comes with our USB Field Upgrade and Configuration Port! We recommend connecting it to a computer BEFORE YOU INSTALL and using our support app "m4cconnect" to do a quick firmware update check. M4cconnect as well as all other information regarding USB update and configuration can be found at www.mods4cars.com/usb. You can even configure and activate your favorite module functions and settings on screen before the module is installed in the car! It is a good idea to permanently install the USB cable with the module in the car, leaving the computer plug in an easily accessible spot for later use with a Wifi/3G/4G connected laptop.
    IMPORTANT TROUBLESHOOTING TIPS

    If the top does not work properly or at all after installing the module, these tips can be very helpful:

    • 1) Turn Function 1 (Main Switch) off (Setting 0). The module will be completely passive. If the problem still persists and the top won't work, check all connections. Please also check the green DATA LED on the module!

    • 2) Function 2 now has a valet mode (Setting 2) on many modules. Valet mode completely disables opening of the top. Check the setting for function 2 and make sure the module is NOT in valet mode!

    IMPORTANT: Not all modules have the valet mode! Please check the Operation and Programming Manual!
    Installation - Steps 1-3
    1. Fully open the convertible top. Move the left seat all the way up as shown, then pull the corner cover piece off in the direction of the arrows. It is only clipped into place.
    2. Directly under the cover piece is the convertible top control unit. Search for the loose white harness connector on the very bottom (1). It is the main disconnect. This is where the SmartTOP module will be connected.
    3. Push down on the locking lever in the middle while wiggling the connectors apart.
    Installation - Steps 4-6
    4. Now connect the plug from the supplied T-harness to the socket. Make sure it latches into place securely.
    5. Then connect the remaining other plug to the matching socket on the SmartTOP harness to complete the circuit.
    6. Lastly, connect the SmartTOP module itself to the 16-way connector on the other end of the harness. The green DATA LED should now light up and thereby show that the module is ready for use. Mount the module to the flat surface of the top controller box using the supplied velcro sticker. We recommend connecting the USB cord and running it to an accessible spot so the module can be configured or updated later coveniently with a laptop. Remember to configure it according to our Operation and Programming manual.